1.AMP EDGE Connectors
。The contact spring absorbs movement while maintaining sufficient contact force
。One-piece printed circuit board connector
2.CR ZIF Connector System
。Modular construction for reliability and economy
。Variety of contacts are available for broad range of mating capabilities
。Plug and receptacle module concept for diversity and replaceability
。Individual modules stand alone and are not disturbed by replacing adjacent modules
。Zero insertion force for blind mating and low contact wear
3.Ribbon Cable Connectors (AMP-LATCH)
。No cable stripping with simultaneous termination of all conductors
。Positive, uniform latching of contacts and housing with cover eliminates cover warpage
。Easy, visual inspection of terminations during assembly; electrical probing capability after assembly
。Shielded connectors provide EMI/RFI protection
4.Taper Pins and Blocks
。Uninsulated and can be supplied with or without insulation support
。Two versions are available -- "F" crimp to terminate the pins and insulation piercing type designed for termination of small, stranded wires and tinsel cords
。The solid Taper Block has the recessed insert (11.94 [.047] on either side) which acts as a barrier to voltage creep
5.TERMI-POINT
。TERMI-POINT clip termination consists of a wire, solid or stranded, connected to a rectangular phosphor bronze clip and retained under pressure
。A compressed spring maintains a continual force between the wire and the post, even under extreme environmental conditions
6.Wrap-Type and TERMI-TWIST Printed Circuit Connectors
。Post engineered for wiring by semi-automatic and hand wrap-type tooling
Contacts incorporate posts for complete compatibility with 0.64 [.025] square wrap-type technology
。One-piece contacts are bifurcated for redundancy and are removable using a simple extraction tool
